 |
 |
 |
|
|
|
[Sponsors] | ||||
August 7, 2021, 21:14
|
Cellzone setting for surface reaction
|
#1 |
|
Senior Member
Mandeep Shetty
Join Date: Apr 2016
Posts: 185
Rep Power: 10  |
Hello, When simulating a surface reaction we define the reaction create the mechanism and set it to wall boundary condition where the reaction takes place. Should we also set the reaction in cellzone condition contact region?
|
|
|
|
|
|
August 8, 2021, 02:08
|
|
#2 |
|
Senior Member
Mandeep Shetty
Join Date: Apr 2016
Posts: 185
Rep Power: 10 |
Can any one please explain this to me? To geometry itself is in 2d with a MRF. The contact region is at the MRF-fluid interface
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 09:53 |
| reaction in UDF(DEFINE_VR_RATE) | louiza | FLUENT | 3 | October 13, 2010 23:59 |
Linear Mode
