|
[Sponsors] |
December 10, 2013, 08:44 |
Domain not remeshing
|
#1 |
New Member
Join Date: Feb 2013
Posts: 16
Rep Power: 13 |
Hi all,
I defined a circular shape in a square domain meshed with triangular elements. Now the circular shape is rotating and translating in the square domain (defined using a cg_motion udf, with sinusoidal shape) and I want the grid to be remeshed as soon as the skewness exceeds 0.7 (I also turn on smoothing for the deformation when no remeshing is needed). When I apply the relevant setting in "dynamic mesh" tab and preview the mesh motion, the smooting occurs but no remeshing is taking place even if the max skewness clearly exceeds 0.7. (local cell option is enabled btw) Anyone suggestions on what might be wrong or where I am defining something wrong? Last edited by adubois; December 10, 2013 at 08:44. Reason: Addition |
|
December 11, 2013, 03:55 |
Additional information
|
#2 |
New Member
Join Date: Feb 2013
Posts: 16
Rep Power: 13 |
In attachment you can see the domain, the inner domain oscillates in the domain (translate and rotates) but the outer domain becomes very skew after a few iterations so I want to apply remeshing but this is not doing anything ... the remeshing does not seem to "turn on".
|
|
May 14, 2014, 10:33 |
|
#3 |
New Member
Jochem Grietens
Join Date: Nov 2013
Location: Belgium
Posts: 16
Rep Power: 12 |
Hi adubois,
I have the exact same problem, have you had any succes in fixing it ? |
|
May 14, 2014, 11:07 |
|
#4 |
New Member
Join Date: Feb 2013
Posts: 16
Rep Power: 13 |
Yes I have, you should only add the moving boundaries as dynamic mesh zones and not the actual "zones" that should be remeshed (is counter intuitive I know). Is it working now?
|
|
May 14, 2014, 14:59 |
|
#5 |
New Member
Jochem Grietens
Join Date: Nov 2013
Location: Belgium
Posts: 16
Rep Power: 12 |
Yes ! it works perfectly now, i would have never found that myself! thank you so much ! strange though !
|
|
May 14, 2014, 15:28 |
|
#6 |
New Member
Join Date: Feb 2013
Posts: 16
Rep Power: 13 |
No problem man, I was a hunch that made me try that and it worked! If I can help with anything else let me know
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Interface between fluid domain and porous domain | windhair | CFX | 6 | May 10, 2018 14:26 |
[ANSYS Meshing] remeshing in Ansys CFX - help or tutorials needed | Doginal | ANSYS Meshing & Geometry | 6 | September 24, 2014 09:43 |
Error (2 isolated fluid regions) with an englobing domain | syens | CFX | 2 | January 12, 2012 10:55 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |