 |
 |
 |
|
|
|
[Sponsors] | ||||
December 23, 2013, 12:09
|
airfoil with negative drag
|
#1 |
|
New Member
Join Date: Dec 2013
Posts: 3
Rep Power: 12  |
Hi,
I have simulated a 2D rear wing with two airfoils. The drag coefficient of the large airfoil is negative, the drag of the smaller one is positive. In my view this is not possible. I use a structural mesh and the k-e-model. Can someone help me? |
|
|
|
|
|
December 23, 2013, 12:15
|
|
#2 |
|
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
Please take a look at the FAQ before inventing a self-propelling airfoil
http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F |
|
|
|
|
|
|
December 28, 2013, 05:54
|
|
#3 |
|
New Member
Join Date: Dec 2013
Posts: 3
Rep Power: 12 |
I have calculated the rear wing with different turbulence models, structured (fine and coarse) and unstructured mesh, 2D and 3D models. The y+ value is between 30 and 300. The pressure portion of the drag is always negative, the viscous portion is positive.
I have also replaced the larger profile with an ellipse body. In this case the drag coefficient is positive… |
|
|
|
|
|
 |
| Tags |
| airfoil2d, negative drag |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Airfoil negative drag coefficent | James Forrest | Main CFD Forum | 9 | September 5, 2022 10:30 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Linear Mode
