|January 16, 2014, 05:23||
Turbulent viscosity limited to viscosity ratio up to 1e+5
Join Date: Sep 2013
Posts: 32Rep Power: 3
Hi friends, I am solving 2D problem in fluent,before solving the problem in fluent i have to check the mesh at that time i got an message like mesh check failed then after wards at the time of run i got an message like turbulent viscosity limited to viscosity ratio of 1e+5. After getting this message i have again refine the mesh, then also i got same message, then i check the boundary condition but that message was not off , however i have aspect ratio nearer the wall is 2.3e+3, so can any one help me what's wrong with me and also plz suggest me what i have to do for removing the above mentioned message ........?
sorry for poor english....
Thank you in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|turbulent viscosity limited to viscosity ratio||Alex_B||FLUENT||16||September 12, 2012 13:17|
|Problem with divergence||TDK||FLUENT||10||September 8, 2012 01:11|
|RSM+2nd ordedr causes turbulent viscosity limited to viscosity ratio of....||khsiavash||Main CFD Forum||7||October 19, 2011 06:21|
|Turbulent viscosity limited to viscosity...||Cyril||FLUENT||16||October 4, 2007 06:12|
|On limiting to turbulent viscosity ratio!||varghese||FLUENT||2||November 15, 2003 09:56|