|
[Sponsors] |
May 24, 2016, 13:57 |
transfer function from step response
|
#1 |
New Member
Join Date: Feb 2016
Posts: 20
Rep Power: 10 |
As in the plot, I initiate a increase at inlet total pressure and check how long the pressure measurement takes to feel the step.The plot has negative value after I normalized parameters. I use bode and the bodeplot does not make sense for me, then switch to fft and it's a mess which has vortex shedding frequency that I cannot tell which is the correct transfer function.
Any suggestions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception error | lpz_michele | OpenFOAM Running, Solving & CFD | 53 | October 19, 2015 02:50 |
Star cd es-ice solver error | ernarasimman | STAR-CD | 2 | September 12, 2014 00:01 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
Error with Wmake | skabilan | OpenFOAM Installation | 3 | July 28, 2009 00:35 |
Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 06:51 |