|
[Sponsors] |
February 16, 2014, 12:30 |
Problems on defining new material property
|
#1 |
New Member
Join Date: Feb 2014
Posts: 4
Rep Power: 12 |
Hi,
I don't know why I kept receiving the error: cx-set-attributes: wta[1](widget) when I was trying to add a new material. The thermal conductivity I wanted to set is orthotropic, but I cannot type any value in. Can someone help? I attached the picture below. |
|
February 17, 2014, 12:13 |
|
#2 |
Member
Join Date: Aug 2013
Location: Bangkok
Posts: 32
Rep Power: 12 |
Can you tell me more information about your step to create the material properties?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
Wall Material | Maple | FLUENT | 4 | March 13, 2009 05:39 |
Liquefied natural gas_LNG material property help! | songxguan | FLUENT | 0 | November 14, 2008 05:50 |
About create new material | jasonchang | CFX | 3 | May 18, 2006 21:07 |