|March 13, 2014, 09:39||
Help with combustion simulation
Join Date: Feb 2014
Posts: 8Rep Power: 4
I'm fairly new to using Ansys software especially fluent and i have to simulate a combustion process in a piston and find the pressure against crank angle graphs. I have gotten to the point where i have the dynamic mesh set up and moving.
i have been trying to run the simulation with no combustion just the gases inside to get the pressure curve as the piston expands and compresses but i keep getting constant pressure regardless of the piston movement.
Is there anyone who may be able to help me understand where the problem is?
|Thread||Thread Starter||Forum||Replies||Last Post|
|literature data for simulation coal combustion||darookie||CFX||1||April 29, 2014 08:50|
|diesel engine combustion simulation||kebi112358||OpenFOAM||4||September 25, 2012 13:16|
|Not burn in Two Step Simulation of A Combustion Chamber||Modest Cat||FLUENT||2||December 5, 2011 05:06|
|Time step for combustion simulation||AdidaKK||CFX||11||December 3, 2009 12:47|
|simulation of diesel combustion||uday||FLUENT||0||October 10, 2009 04:15|