|
[Sponsors] |
March 13, 2014, 08:39 |
Help with combustion simulation
|
#1 |
New Member
Michael Hilton
Join Date: Feb 2014
Posts: 8
Rep Power: 12 |
Hi everyone,
I'm fairly new to using Ansys software especially fluent and i have to simulate a combustion process in a piston and find the pressure against crank angle graphs. I have gotten to the point where i have the dynamic mesh set up and moving. i have been trying to run the simulation with no combustion just the gases inside to get the pressure curve as the piston expands and compresses but i keep getting constant pressure regardless of the piston movement. Is there anyone who may be able to help me understand where the problem is? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
literature data for simulation coal combustion | darookie | CFX | 1 | April 29, 2014 08:50 |
diesel engine combustion simulation | kebi112358 | OpenFOAM | 4 | September 25, 2012 13:16 |
Not burn in Two Step Simulation of A Combustion Chamber | Modest Cat | FLUENT | 2 | December 5, 2011 04:06 |
Time step for combustion simulation | AdidaKK | CFX | 11 | December 3, 2009 11:47 |
simulation of diesel combustion | uday | FLUENT | 0 | October 10, 2009 04:15 |