|
[Sponsors] |
Pressurized release of gas using ANSYS Fluent: are these settings correct? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 12, 2014, 17:42 |
Pressurized release of gas using ANSYS Fluent: are these settings correct?
|
#1 |
New Member
Join Date: Apr 2014
Posts: 4
Rep Power: 12 |
I am currently trying to model the pressurized release of air from a 1000 psi tank into a chamber. I'm currently using Density-based settings because I couldn't seem to get a solution when I used Pressure-based settings.
This is how I set up the model: 1) Set everything as a wall, except for the furthest face which I defined as a Pressure outlet at 1 atm; 2) initialize the whole fluid domain as 1atm air, 0 velocity; 3) Adapt > Region > Choose coordinates so the tank points are selected; 4) Patch region as 1000 psi. The pressure contour plot is correct initially. I just want to know if these settings are correct, because when I ran the simulation the tank pressure remained at a constant 1000 psi instead of going down like it should in real life. |
|
April 14, 2014, 22:32 |
|
#2 |
New Member
Join Date: Apr 2014
Posts: 4
Rep Power: 12 |
Anyone? I have pretty much setup everything, just probably some minute tweaking of the settings.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
from gambit to ansys fluent | vpdchispas | ANSYS Meshing & Geometry | 1 | March 25, 2011 17:53 |
ANSYS file into Fluent | Liaquat | FLUENT | 4 | April 17, 2006 10:32 |
Ansys to aquire FLUENT | Michael Bo Hansen | CFX | 74 | February 24, 2006 20:42 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |