|April 15, 2014, 23:57||
Heat transfer between two bodies
Join Date: Oct 2011
Posts: 80Rep Power: 7
I have two blocks separated by a small distance. I initialize the bodies with 30 degrees and patched one body at 500 degrees. I am trying two methods to solve this.
I create the two bodies and fluid domain, then create interfaces where required.
Another is selecting all bodies on Design modeler and making them as a single part. This creates them as walls with coupled condition for thermal.
Are these methods correct and same?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Error finding variable "THERMX"||sunilpatil||CFX||8||April 26, 2013 07:00|
|Question about heat transfer simulation||Anna Tian||Main CFD Forum||0||January 25, 2013 19:53|
|Modelling the heat transfer during compression and cooling of natural gas||pano||Main CFD Forum||0||December 10, 2010 16:53|
|Heat Transfer in Porous Medium||eryan||STAR-CD||0||September 28, 2010 13:14|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|