coal combustion temperature failure
Hi everyone,
I m trying to simulate coal combustion in a boiler, and I got this error "temperature limited to 1.000000e+00" at particle injection location. How can I fix this problem? Regads |
Also I have to change air properties(viscosity, cp, thermal conductivity etc.). How can I change properties of air?
|
Even i get that Temperature limited to error i dont think its a problem
|
Quote:
|
My boundary condition is set to 300K. If I close the injection, there is no failure, but If I open it, temperature limits to 1 K.
|
All times are GMT -4. The time now is 09:33. |