|May 8, 2014, 02:12||
Profile data to initialize cell zone variables
Join Date: Dec 2009
Posts: 23Rep Power: 7
I am trying to copy data from one mesh to an expanded mesh in Fluent. I want to use the Profile command to input the data from a previous result into a new mesh in the cell zones. I have read the data and can plot the data, but it will not initialize the variables for the calculation in the cell zone region (with or without initialization).
The help file says this should work, but I am not successful. Any suggestions?
|fluent, initialization, profile|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[GAMBIT] periodic faces not matching||Aadhavan||ANSYS Meshing & Geometry||6||August 31, 2013 11:25|
|About Cell Zone Conditions||Liufeng_ustb||FLUENT||0||May 17, 2013 23:28|
|Change cell zone index/thread during simulation||neilduffy1024||FLUENT||0||January 17, 2011 10:40|
|Cells with t below lower limit||Purushothama||CD-adapco||2||May 31, 2010 21:58|
|CFXSolver Error Message using Profile Data on B||Tobias||CFX||0||August 26, 2005 07:27|