two phase separation
Hi,
Currently, I am doing Fluent simulation regarding to the two phase separation at tee pipe. Below are my input parameters air velocity = 27.432 m/s water velocity = 0.02339 m/s volume fraction of water = 0.00085 flow rate weighing at side arm = 0.3 flow rate weighing at run arm = 0.7 In the result, the % of gas going into the side arm is approximately accurate but the % of liquid going into the side arm is inaccurate and its value is the same as % of gas going into side arm. Same problem is observed when I am trying to manipulate the flow rate weighing of both side and run arm. Maybe the amount of water is too small. Any idea on this problem ??? thanks in advance :) |
All times are GMT -4. The time now is 13:39. |