|August 21, 2014, 21:52||
define a time dependent inlet velocity
Join Date: Feb 2013
Posts: 23Rep Power: 5
Since nobody can figure out how to make fluent initialize the Cell Zone Conditions properly to contain a mixture, I will use this workaround.
I figure I can have the inlet run long enough to fill the interior with the mixture since fluent cannot start the simulation with the interior full of the mixture as an initial condition. But to do this I need to have the inlet velocity run for, say, 5 seconds to fill the tank, then shut off for the rest of the simulation.
So is there a simple way to have fluent run at v0 for only 5 seconds then set the inlet velocity to 0?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Moving mesh||Niklas Wikstrom (Wikstrom)||OpenFOAM Running, Solving & CFD||122||June 15, 2014 06:20|
|Reusing the inlet time directories in timeVaryingMappedFixedValue||ngj_22||OpenFOAM Running, Solving & CFD||0||January 24, 2013 11:22|
|Missing math.h header||Travis||FLUENT||4||January 15, 2009 12:48|
|Free surface boudary conditions with SOLA-VOF||Fan||Main CFD Forum||10||September 9, 2006 12:24|
|UDF problem : inlet velocity in cyl. coord. system||Jongdae Kim||FLUENT||0||June 15, 2004 11:21|