|
[Sponsors] |
reading boundary conditions data at inlet from .dat file |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 17, 2014, 04:21 |
reading boundary conditions data at inlet from .dat file
|
#1 |
Member
Iman
Join Date: Nov 2013
Posts: 37
Rep Power: 12 |
Hi
i have tabulated data of velocity, k and e from actual experiment in .dat type. how can i set fluent to read from this file for the inlet conditions? also if i want to set k-e using the relationship e=C*k^1.5 how and where to specify that? any help/advice or reference is highly appreciated |
|
September 17, 2014, 07:30 |
|
#2 |
Senior Member
Join Date: Nov 2013
Posts: 1,965
Rep Power: 26 |
You should write a UDF for that. Look in the UDF manual for DEFINE_PROFILE, there are some examples that might help you further.
|
|
September 17, 2014, 21:02 |
|
#3 |
Member
Iman
Join Date: Nov 2013
Posts: 37
Rep Power: 12 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |