Floating point exception/diversion detected
I am modelling an impinging jet with a high inlet temperature (1000K) at a Reynolds nr of 23000 with the jet diameter as the reference length.
When I try to run the case, it immediately explodes, but when I change only the inlet temperature to 400K, the simulation runs, and seems to keep on running if I stop the analysis and incrementally increase the temperature, it however terminated again when I reach 460K (also floating point error). This is however not a very elegant solution. Are there settings in FLUENT that I can use to manage this instability? Thanks in advance. |
All times are GMT -4. The time now is 07:32. |