|October 28, 2014, 06:43||
Jump in Transient Simulations Monitor
Join Date: Jul 2012
Posts: 5Rep Power: 5
I am simulating a 2D methane-air premixed combustion in transient mode.
Whenever I stop and rerun my transient calculations, I see a jump in the monitors I have defined. And then again I need to wait quite some time to get to steady value.
Why is this?
Is it because I may have stopped in the middle of iterations per time step? And the next time step starts from a not converged solution in the previous time step?
What would be solution for me? Enabling auto save that saves exactly when a time step is finished?
Thank you for your help.
|fluent, jump, monitor, transient|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Low Mixing time Problem||Mavier||CFX||5||April 29, 2013 00:00|
|Transient simulations: how to tell its converged (I've read the FAQ & user guides!)||JuPa||CFX||10||March 12, 2013 10:02|
|Sequential Transient Simulations||Jinglz||FLUENT||0||November 14, 2012 11:40|
|Minimal transient result lokks like full in Post||Korsh Mik||CFX||14||July 19, 2005 02:45|
|URANS and Transient Simulations||bob||Main CFD Forum||0||October 1, 2003 03:54|