 |
 |
 |
|
|
|
[Sponsors] | ||||
September 15, 2017, 06:33
|
Fluent - Solar Radiation Model
|
#1 |
|
New Member
Join Date: Jul 2017
Posts: 4
Rep Power: 8  |
Guys!!! Pls help, I think i am going crazy soon......
I am an amateur in CFD and i am investigating a case involving solar radiation effect on the room temperature. Therefore, I start by a very simple box for testing. I have activated the solar tracing model. After setting up the material and boundary condition, I initialize the model with standard initialization. Then, I went to look at the "Solar Heat Flux" under the "Wall Fluxes..." , the result shows zero everywhere  Could anyone pls help me talk a look at my procedures (attached) and correct me if i have done anything wrong p.s. all boundaries are with the same materials properties and settings (i.e. Figure 3 & 4) |
|
|
|
|
|
September 15, 2017, 06:35
|
Rest of Procedures
|
#2 |
|
New Member
Join Date: Jul 2017
Posts: 4
Rep Power: 8 |
Rest of the procedures.......
|
|
|
|
|
|
 |
| Tags |
| solar ray tracing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Coupling RPI wall boiling model with population balance model in Fluent | softice2006 | Fluent Multiphase | 1 | April 19, 2023 02:09 |
| Issue with radiation direction in fluent DO Model | SBhat | FLUENT | 4 | October 24, 2020 05:57 |
| Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
| Radiation Modeling | Chris89 | CFX | 20 | August 14, 2014 07:51 |
| how solar radiation data hooked to fluent? | alemu | FLUENT | 0 | July 14, 2006 08:41 |
Linear Mode
