|
[Sponsors] |
July 23, 2017, 17:08 |
direction of rotating blade
|
#1 |
New Member
Join Date: Apr 2017
Posts: 3
Rep Power: 9 |
Hi everyone,
I am making analysis of helicopter rotor blade with Fluent. But unfortunately when i modelled rotor blade, i draw it clockwise direction by mistake. I tried so hard to generate mesh so i don't want to do everything from the very beginning. Does it matter which direction it turns? (I just need Cp values) If it does, can i fix it without doing everything all along? Thanks in advance. quasimodo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Car external aerodynamic with wheel spinning issue | hokhay | FloEFD, FloWorks & FloTHERM | 2 | August 18, 2016 04:23 |
[TurboGrid] Slotted rotor Blade using Turbogrid | drcsm | ANSYS Meshing & Geometry | 0 | March 15, 2016 00:26 |
Blade rotating in swirling flow | Declan | FLUENT | 1 | February 2, 2015 09:28 |
Centrifugal Pump Simulation Problem! | warex | FloEFD, FloWorks & FloTHERM | 29 | September 23, 2014 10:27 |
Mesh type in rotating blade inside cylinder | Mah.tavana | Mesh Generation & Pre-Processing | 0 | July 26, 2014 06:53 |