Auto saving of mass flow rate or discharge with time step

Tanjina · December 1, 2014, 00:35

Hello,

Is there any way that I can make Ansys Fluent to autosave the mass flow rate/discharge through pipe outlet after certain time step ? I tried with 'export" option, but I couldn't export the mass flow rate. Then I exported velocity and tried to calculate mass flow rate/ discharge manually, unfortunately I found different result from Fluent. Both should be same, right ?

Any help will be highly appreciated.

Regards,
Tanjina

Kokemoor · December 1, 2014, 10:36

If you create a monitor of the mass flow rate, you can have it write to file every time step. Check out the Fluent User's Guide, section 28.15, in particular 28.15.4.

Tanjina · December 1, 2014, 14:15

Thanks Kokemoor. It is working!

I made it to write every 150 time step and set another monitor to display mass flow rate at every iteration. Initially I thought I can't make two monitor for one parameter with different time step. But I can !

Thanks a lot.

December 1, 2014, 00:35	Auto saving of mass flow rate or discharge with time step	#1
Tanjina Senior Member Tanjina Afrin Join Date: May 2013 Location: South Carolina Posts: 169 Rep Power: 12	Hello, Is there any way that I can make Ansys Fluent to autosave the mass flow rate/discharge through pipe outlet after certain time step ? I tried with 'export" option, but I couldn't export the mass flow rate. Then I exported velocity and tried to calculate mass flow rate/ discharge manually, unfortunately I found different result from Fluent. Both should be same, right ? Any help will be highly appreciated. Regards, Tanjina

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AMI speed performance	danny123	OpenFOAM	21	October 24, 2020 04:13
Target Mass Flow Rate	Nitin	FLUENT	9	June 17, 2017 10:30
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Micro Scale Pore, icoFoam	gooya_kabir	OpenFOAM Running, Solving & CFD	2	November 2, 2013 13:58
mixerVesselAMI2D's mass is not balancing	sharonyue	OpenFOAM Running, Solving & CFD	6	June 10, 2013 09:34

December 1, 2014, 10:36		#2
Kokemoor Senior Member Andrew Kokemoor Join Date: Aug 2013 Posts: 122 Rep Power: 13	If you create a monitor of the mass flow rate, you can have it write to file every time step. Check out the Fluent User's Guide, section 28.15, in particular 28.15.4.

December 1, 2014, 14:15		#3
Tanjina Senior Member Tanjina Afrin Join Date: May 2013 Location: South Carolina Posts: 169 Rep Power: 12	Thanks Kokemoor. It is working! I made it to write every 150 time step and set another monitor to display mass flow rate at every iteration. Initially I thought I can't make two monitor for one parameter with different time step. But I can ! Thanks a lot.