|
[Sponsors] |
January 30, 2015, 06:58 |
Problem with continuity
|
#1 |
Member
Nikolaos Babilas
Join Date: Nov 2014
Posts: 37
Rep Power: 11 |
Hello everyone. I have the below geometry. i try to model combustion but always something goes wrong. for this reason i put cold air to the inlets to have some results. the result was that in approximately in the 2500 iteration continuity and e started to diverge (turbulence viscocity in * cells etc). i dont know what is going wrong. where do you believe in this geometry should i have better mesh if i want to model combustion and with which model should i use?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Continuity residual problem | enayath | FLUENT | 0 | June 23, 2014 12:46 |
continuity residual problem | flow_CH | FLUENT | 6 | July 23, 2013 03:46 |
same geometry,structured and unstructured mesh,different behaviour. | sharonyue | OpenFOAM Running, Solving & CFD | 13 | January 2, 2013 23:40 |
convergence problem when use pisoFoam, LES for wind tunnel case | Forrest_Lei | OpenFOAM | 3 | July 19, 2011 07:00 |
problem with continuity residual | dario | FLUENT | 1 | October 1, 2006 08:23 |