 |
 |
 |
|
|
|
[Sponsors] | ||||
June 20, 2016, 17:50
|
FSI Dynamic Mesh Separating?
|
#1 |
|
New Member
Devin
Join Date: Jun 2016
Posts: 2
Rep Power: 0  |
Hello Everyone,
I'm trying to model a basic reed valve in fluid flow using 2 way coupled FSI with Ansys Mechanical and Fluent. Everything seemed to be going well, but I wasn't getting the flows I expected. On closer inspection, I noticed while my reed valve was being opened by the fluid flow, the mesh is separating, rather than expanding and remeshing in that area. Hopefully the pictures below will better explain my issue. Thanks for the help. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh | kennyboy | FLUENT | 1 | February 23, 2019 01:52 |
| Local mesh refinement definition in a DEFORMING dynamic mesh zone using Dynamic Mesh | Emanuele88 | FLUENT | 0 | February 9, 2016 11:39 |
| FSI. Fluent divergence issue due to Dynamic Mesh | Svensen | ANSYS | 2 | January 28, 2016 01:41 |
| dynamic mesh refinement and rhoCentralFoam | ChrisA | OpenFOAM Running, Solving & CFD | 1 | March 21, 2013 08:00 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
