|May 28, 2015, 16:54||
Temperature continuity between domains
Join Date: Mar 2015
Posts: 8Rep Power: 2
SOLVED: using the Fluent "Graphic and animation", instead of CFD-Post
I'm trying to simulate a natural convection in a garage, with solar radiation and heat flux between the different domains, but there is no continuity between them and I tried a lot of configurations and thermal setups. Also I serched online and in the forum a solution, but I found nothing.
This one is an exercise model for this case:
Initial conditions 15°C
Terrain with a UDF temperature (from 24°C to 18°C)
Do you know how to have this thermal continuity between the fluid?
Last edited by Jackino777; May 28, 2015 at 20:19.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|InterFoam negative alpha||karasa03||OpenFOAM||7||December 12, 2013 04:41|
|dynamic Mesh is faster than MRF????||sharonyue||OpenFOAM Running, Solving & CFD||14||August 26, 2013 07:47|
|interDyMFoam "time step continuity errors"||kilroy||OpenFOAM Running, Solving & CFD||4||May 7, 2013 01:39|
|Inlet won't apply UDF and has temperature at 0K!||tccruise||Fluent UDF and Scheme Programming||2||September 14, 2012 06:08|