|June 2, 2015, 10:11||
issue in mass flow rate graph
Join Date: Oct 2013
Location: Somewhere on Earth
Posts: 343Rep Power: 6
Here I have a strange issue,
I' modeling an axisymmetric 2 phases flow in a tube,
at the end of simulation, I plot the mass flow rate graph some section across the radius, but there is an issue,
As it's clear in the pictures, mass flow rate for each phase near the axis is zero!
I guess it's logical to mass flow be Max. at the axis, so I think it's irrational!
what do you think!? you think these graphs wrong too!!?
Last edited by amin.z; June 2, 2015 at 13:04.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pressure Outlet Targeted Mass Flow Rate||LuckyTran||FLUENT||0||March 9, 2015 01:26|
|Mass flow rate of phase in post||mat_cfd||CFX||0||September 3, 2013 07:55|
|Mass Flow Rate Error||jallison||FLUENT||1||May 16, 2011 16:22|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|mass flow rate error||Masood||FLUENT||0||May 22, 2005 00:32|