suppress the body??

piyusharas · July 7, 2015, 01:14

Just consider I am modelling a flow in which water comes from a inlet on top an it splashes on the bottom wall of tank kept 40 mm down the inlet and then distributes in 6 symmetric outlets in the plate.
I am using a VOF model with primary phase as air and secondary phase as water.

Just tell me one thing that during I make the geometry should I suppress the tank (body in which I filled my fluid domain) or continue with it.
Will it make some difference.

bhanuday.sharma · July 7, 2015, 01:50

You should suppress it.

piyusharas · July 7, 2015, 02:13

then in boundary condition should i set faces of solid generated as walls or something else..
There is no need of interface .. Is it???

piyusharas · July 7, 2015, 02:20

And one more thing initially my tank is empty and water in coming from inlet so what should i do during initialization and patching/adapt.
please explain a little

July 7, 2015, 01:14	suppress the body??	#1
piyusharas Member Piyush Aras Join Date: Jun 2015 Posts: 34 Rep Power: 10	Just consider I am modelling a flow in which water comes from a inlet on top an it splashes on the bottom wall of tank kept 40 mm down the inlet and then distributes in 6 symmetric outlets in the plate. I am using a VOF model with primary phase as air and secondary phase as water. Just tell me one thing that during I make the geometry should I suppress the tank (body in which I filled my fluid domain) or continue with it. Will it make some difference.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
6dof model - floating body	flinde	FLUENT	13	March 6, 2021 14:32
WILLING TO PAY/ FREELANCER REQUIRED / small UDF coding force loads over body / 6DOF	acasas	CFD Freelancers	1	January 23, 2015 07:26
Beginner questions - modelling lift and drag on a towed body	ABF	Main CFD Forum	15	October 19, 2014 23:27
6DOF with floating body bounce back.	paka	FLUENT	4	June 6, 2013 11:32
[Need some advise] Am I doing right?? Simulating a rotational mixer	setasena	STAR-CCM+	4	March 10, 2013 10:32

July 7, 2015, 01:50		#2
bhanuday.sharma New Member Bhanuday Sharma Join Date: Jun 2015 Posts: 18 Rep Power: 10	You should suppress it.

July 7, 2015, 02:13		#3
piyusharas Member Piyush Aras Join Date: Jun 2015 Posts: 34 Rep Power: 10	then in boundary condition should i set faces of solid generated as walls or something else.. There is no need of interface .. Is it???

July 7, 2015, 02:20		#4
piyusharas Member Piyush Aras Join Date: Jun 2015 Posts: 34 Rep Power: 10	And one more thing initially my tank is empty and water in coming from inlet so what should i do during initialization and patching/adapt. please explain a little