|
[Sponsors] |
July 14, 2015, 11:09 |
flow over a cylinder with suction ports
|
#1 |
New Member
giosue giacoppo
Join Date: Sep 2012
Posts: 9
Rep Power: 13 |
Dear all,
I'd like to simulate a hot body (almost cylindrical) enclosed in a tube (200mm diameter). In this hot bohdy I've also two holes where a fixed mass flow rate is sucked from the surrounding fluid volume. How deal with these kinds of internal boundaries? regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drag force coefficient too low for a flow past cylinder at Re= 1e05 | Scabbard | STAR-CCM+ | 2 | June 5, 2020 15:44 |
Flow past a cylinder at Re 1e05 using LES, drag force coefficient is to low | Scabbard | Main CFD Forum | 21 | June 19, 2018 14:58 |
benchmark: flow over a circular cylinder | goodegg | Main CFD Forum | 12 | January 22, 2013 12:47 |
flow around a cylinder | pXYZ | Main CFD Forum | 14 | July 25, 2011 11:05 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |