|July 17, 2015, 02:45||
Calculation of Coefficient of Drag of simplified car model.
Join Date: Mar 2014
Location: Tamilnadu, Chennai, India
Posts: 7Rep Power: 3
I am trying to analyse the simplified car model of length 410mm in Ansys Fluent 15 and I am fixing the fluid velocity as 14.95 m/s and computational domain dimensions as L=2000mm, W=1200mm, H=1000mm and I calculated reynolds no as 4.207e5 and turbulent intensity as 0.0311 and hydraulic diameter as 1.090.
I had entered the boundary condition for Velocity inlet with above calculated values Turb.intensity, Hy dia, then pressure oulet with K and Epsilon as default values as 1 for both. The result shows [B]Cd value shows 0.16 but the actual Cd value of the model is 0.3, So kindly anyone assist me that where I had done the mistake.
Formulas I had used are
Hy dia=(4*1*1.2)/Perimeter of domain
Kindly anyone reply me as soon as possible.
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Incorrect Drag and Drag Coefficient for flow over a cylinder||ozzythewise||Main CFD Forum||8||June 13, 2012 06:24|
|Pressure drag calculation||lc05||Main CFD Forum||2||November 1, 2010 08:50|
|Drag and Lift coefficient calculation||viraj||Main CFD Forum||0||February 5, 2010 06:41|
|Automotive test case||vinz||OpenFOAM Running, Solving & CFD||98||October 27, 2008 09:43|
|Warning 097-||AB||CD-adapco||6||November 15, 2004 05:41|