 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2015, 07:08
|
Conection over cylinder
|
#1 |
|
New Member
vignesh.r
Join Date: Sep 2015
Posts: 8
Rep Power: 10  |
CONVECTION OVER CYLINDER......I want to calculate nu at particular angle of cylinder(45,90,180,270) please any one help.......
|
|
|
|
|
|
September 19, 2015, 11:22
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,672
Rep Power: 65 |
Is that a single point or a line? Create a point or line at those locations and then you can report just the Nu along the point/line. You can also make a monitor.
|
|
|
|
|
|
|
September 21, 2015, 11:02
|
|
#3 |
|
New Member
vignesh.r
Join Date: Sep 2015
Posts: 8
Rep Power: 10 |
thank yuuu
|
|
|
|
|
|
|
September 22, 2015, 06:42
|
udf code
|
#4 |
|
New Member
vignesh.r
Join Date: Sep 2015
Posts: 8
Rep Power: 10 |
i want udf code for this condition....i want to fluent analyis in regenrator....in pipe fluid having left side as inlet for particular period after that fluid inlet has to be given at right side. ..like this inlet conditon has to be varied over 50 cycles,....please any one help me for the udf code.....
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drag force coefficient too high for a flow past a cylinder using komega sst | Scabbard | OpenFOAM Running, Solving & CFD | 37 | March 21, 2016 16:16 |
| Forces Acting on a Rotating Cylinder (Moving Mesh) | dreamchaser | CFX | 5 | April 25, 2015 06:01 |
| Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
| [blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
| Turbulent steady flow around a circular cylinder | Mirek Kabacinski | FLUENT | 0 | July 23, 2003 18:40 |
Linear Mode
