|
[Sponsors] |
October 25, 2015, 13:42 |
Heat generation rate
|
#1 |
New Member
wili
Join Date: Oct 2015
Posts: 2
Rep Power: 0 |
Hi everyone,
I am new in ansys fluent. I want simulate flow over rectangular cylinder with constant temperature at wall after that with heat generation. The contours of temperature with T=cte are correct But using a heat generation There is no contours of temperature: Can someone help please. Thanks |
|
October 25, 2015, 13:45 |
|
#2 |
New Member
wili
Join Date: Oct 2015
Posts: 2
Rep Power: 0 |
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total heat release rate - variation not expected | Bufacchi | OpenFOAM Running, Solving & CFD | 14 | May 15, 2020 06:35 |
Heat Generation rate in W/m³ | ashghan | OpenFOAM Programming & Development | 0 | June 27, 2014 05:42 |
Enforce bounds error with heat loss boundary condition at solid walls | Chander | CFX | 2 | May 1, 2012 20:11 |
HOW TO GIVE BODY HEAT GENERATION TERM | NITUL KALITA | FLUENT | 3 | December 18, 2008 11:23 |
heat generation rate w/m3 in 2D | Laszlo | FLUENT | 1 | May 6, 2004 11:58 |