|
[Sponsors] |
October 26, 2015, 03:41 |
Electrolysis problem in Fluent
|
#1 |
Member
|
Dear All,
I am asking for some advice on the Electrolysis module of Fluent. I am getting an error " received a fatal signal (segmentation fault)". Whenever I try to set the model as Electrolysis the anode should be set up as current collector and cathode need to reduction potential. I am unable to do that. I am working on batch reactor which does not have an inlet and outlet. The experimental result has given me the limiting current which need to the limiting point for the converged result. Now how to do this in Fluent is the question. Is it necessary to go for a tailor made UDF or is there any other way to solve this. I am struck in this and need advice on this. I have attached the templates required for Fluent and the limiting conditions. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 09:07 |
Problem with Volumetric Reactions in Fluent | Kashif Rashid | Fluent UDF and Scheme Programming | 2 | December 28, 2017 00:36 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
fluent parallel problem in win7 x64 system | dunga82 | FLUENT | 8 | April 19, 2012 20:23 |
Fluent parallel license problem | brothershuai | Main CFD Forum | 0 | July 1, 2009 15:41 |