|November 7, 2015, 05:13||
Mass Flow rate in DPM model
Join Date: Nov 2015
Posts: 1Rep Power: 0
in ansys fluent,in the injection tab for DPM, I am asked to insert several parameters;including diameter of particle, velocity of particle and mass flow rate. (We know massflowrate=rho*v*A)
i'm wondering myself if I insert diameter of particle (A obtains from diameter of particle) and Velocity (V); based on massflowrate=rho*v*A ; the mass flow rate would be determined, so why we have to insert the mass flow rate again !!!???
What is the difference between inserted mass flow rate and calculated mass flow rate by formule of mdat=rho*v*A ???
|diameter of particle, dpm fluent, mass flow rate|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discrete Phase Model, outlet mass flow rate does not fit||edu_aero||FLUENT||28||September 18, 2015 06:53|
|mass flow rate not conserved in turbomachine, interface defined wrong?||wildli||FLUENT||2||July 8, 2015 11:38|
|mass flow inlet and pressure outlet with target mass flow rate||Zigainer||FLUENT||10||January 5, 2013 22:51|
|Dpm injection mass flow rate||diamondx||FLUENT||0||November 22, 2012 14:04|
|Target mass flow rate||Saturn||FLUENT||0||December 10, 2004 05:18|