Absolute pressure and temperature limited
Hello guys,
Currently I'm model a blast wave using 'patch'. Setting: Density-based, transient, inviscid, 2D model and 1 atm for the ambient. Before this I set the 'patch' pressure : 40 atm (for testing) and it went well and I got the blast wave contours. Then, I change the value to real blast detonation pressure (PE4) : 243770 atm, but the blast wave did not occur. When start the simulate, the absolute pressure and temperature limited in 6 cells on zone 2. I've tried to reduce the limit at solve>control but nothing happen. The error still occur. Please help me regarding this problem. Thank you |
I don't think there's any problem other than you need to increase the limits.
Did you increase or decrease the limits? |
Yes LuckyTran, I already change and play around with the limits but the problem still happen.
In this settings, the boundary condition, I only define the farfield as a pressure oultet. I'm not define any pressure inlet in the boundary condition. is this will contribute to the error? I only do patch at the wall surface and simulate |
All times are GMT -4. The time now is 23:51. |