|December 28, 2015, 08:11||
How to get the results of a certain face in FLUENT
Join Date: Aug 2014
Posts: 22Rep Power: 4
I been modeling a 90 degree elbow(single phase). And I need the results in the first layer(which is 0.006mm high because I try to make y+=1).
When the height of first layer about 0.2mm, I can draw a interface(0.2mm away from wall) in ICEM using mesh merge(dividing the elbow into two parts,one stands for the outer elbow has a thickness about 0.2mm),but when it is 0.006mm, it seems ICEM can't draw that face.
So I wondering if there are other ways to get such a face, which I can use to do further research. Or what should I do in Fluent or other software?
|Thread||Thread Starter||Forum||Replies||Last Post|
|water inject tube, huge different results by icoFoam and Fluent||cchuran||OpenFOAM Running, Solving & CFD||5||August 3, 2015 08:05|
|Results from REAL experiment and FLUENT are not equal ?||notecool24||FLUENT||3||January 19, 2014 18:41|
|Diffent Results between OpenFOAM and Fluent||biau||OpenFOAM Running, Solving & CFD||10||July 15, 2013 09:31|
|2d to 3d mapping of results in fluent||luizebs||FLUENT||0||September 5, 2012 20:58|
|Import problem||ARC||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||February 27, 2010 11:56|