 |
 |
 |
|
|
|
[Sponsors] | ||||
January 11, 2016, 09:18
|
Adapt circular region on a square mesh
|
#1 |
|
New Member
Murtaza Abbas
Join Date: Nov 2015
Posts: 5
Rep Power: 10  |
Hi,
My mesh consists of square cells which get smaller in both directions towards the bottom left corner. I'm trying to patch a circle on to the mesh, however I don't get a sharp boundary and it doesn't really look like a circle. Is there a workaround to this? Thanks in advance |
|
|
|
|
 |
| Tags |
| adapt, mesh, region meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Material properties in multi region foam and refining mesh for each region | mukut | OpenFOAM Meshing & Mesh Conversion | 2 | October 7, 2013 02:08 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
