Using DPM to get the Spray

pkp · February 25, 2016, 21:28

Hello everybody,

I am working on a geometry which is actually 3D, but for the starting phase, I am using a 2D model. It is the part of the combustion chamber in the rotary IC engine. My main task is to design the fuel injector, to get the spray from the injector. Initially I am using a simple circular pipe as a fuel injector. The outlet of the fuel injector is 0.1 mm.
I have read few tutorials for the DPM. Please tell me what can be the thing to start with a injection ?
Do I need to design the injector physically ?
If some of you have some good useful tutorial on the Spray modelling, please send me on my email ID.
parthmech19@gmail.com

If someone wants to hands on with my problem, I will send my mesh file with boundary condition.

All suggestions are welcome. Thank you in advance.

Tensian · June 7, 2016, 06:50

Hi pkp,

I am trying to simulate spray cooling of metal pieces.

Have you found a suitable tutorial? I have seen the tutorials that ANSYS provides but I need to include heat transfer (I need to investigate cooling of the metal piece depending on spray parameters).

Is your model working now?

Thanks!

February 25, 2016, 21:28	Using DPM to get the Spray	#1
pkp New Member Presteina Join Date: Feb 2016 Location: Canada Posts: 16 Rep Power: 10	Hello everybody, I am working on a geometry which is actually 3D, but for the starting phase, I am using a 2D model. It is the part of the combustion chamber in the rotary IC engine. My main task is to design the fuel injector, to get the spray from the injector. Initially I am using a simple circular pipe as a fuel injector. The outlet of the fuel injector is 0.1 mm. I have read few tutorials for the DPM. Please tell me what can be the thing to start with a injection ? Do I need to design the injector physically ? If some of you have some good useful tutorial on the Spray modelling, please send me on my email ID. parthmech19@gmail.com If someone wants to hands on with my problem, I will send my mesh file with boundary condition. All suggestions are welcome. Thank you in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Modelling solid cone water spray using DPM	vigii	Fluent Multiphase	1	October 24, 2013 07:39
Coupled DPM water spray inside enclosed volume of air	dan86	FLUENT	0	July 19, 2013 11:23
DPM Particle types, Spray Dryer	Mohsin	FLUENT	1	August 2, 2011 21:26
dpm spray into open air	kev	FLUENT	1	December 3, 2005 02:52
DPM spray angle	David	FLUENT	0	December 8, 2003 05:45

June 7, 2016, 06:50		#2
Tensian Senior Member James Join Date: May 2013 Posts: 116 Rep Power: 12	Hi pkp, I am trying to simulate spray cooling of metal pieces. Have you found a suitable tutorial? I have seen the tutorials that ANSYS provides but I need to include heat transfer (I need to investigate cooling of the metal piece depending on spray parameters). Is your model working now? Thanks!