Use boundary condition type as parameter

johanhyrefeldt · May 3, 2016, 09:09

Hi!

In my Fluent problem I have an inlet and outlet divided into different segments. The inlet consists of 6 adjacent faces, each with its own named selection, and therefore I can choose to close one inlet segment by changing the BC-type to "wall" instead of my other option "pressure-inlet". The same applies for the outlet segments and I can switch these between "pressure-outlet" and "wall".

My problem is that I want to create a parameter for each inlet/outlet segment that can switch the BC-type between "wall" and "pressure-inlet/outlet". My idea is to run a DOE in workbench containing parameters for the BC-types and get results for different combinations of open/closed segments. Is there any way to create a parameter set with one parameter for each inlet segment and outlet segment where the values of the parameters are either "wall" or "pressure-inlet" respectively "pressure-outlet"?

cibi · November 7, 2023, 10:00

Hi Johan,

Did you eventually find a solution?
I am currently trying to do the same thing.

Thanks
Claudia

May 3, 2016, 09:09	Use boundary condition type as parameter	#1
johanhyrefeldt New Member Johan Hyrefeldt Join Date: Apr 2016 Posts: 1 Rep Power: 0	Hi! In my Fluent problem I have an inlet and outlet divided into different segments. The inlet consists of 6 adjacent faces, each with its own named selection, and therefore I can choose to close one inlet segment by changing the BC-type to "wall" instead of my other option "pressure-inlet". The same applies for the outlet segments and I can switch these between "pressure-outlet" and "wall". My problem is that I want to create a parameter for each inlet/outlet segment that can switch the BC-type between "wall" and "pressure-inlet/outlet". My idea is to run a DOE in workbench containing parameters for the BC-types and get results for different combinations of open/closed segments. Is there any way to create a parameter set with one parameter for each inlet segment and outlet segment where the values of the parameters are either "wall" or "pressure-inlet" respectively "pressure-outlet"?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Time step continuity error	lpz_michele	OpenFOAM Running, Solving & CFD	0	October 12, 2015 06:05
interFoam/kOmegaSST tank filling with printStackError/Mules	simpomann	OpenFOAM Running, Solving & CFD	3	February 17, 2014 17:06
Pressure instability with rhoSimpleFoam	daniel_mills	OpenFOAM Running, Solving & CFD	44	February 17, 2011 17:08
Boundary condition setting for non-premixed combustion using reactingFoam	skyopener	OpenFOAM	0	May 23, 2010 22:55
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

November 7, 2023, 10:00		#2
cibi New Member Cla Join Date: Nov 2020 Posts: 4 Rep Power: 5	Hi Johan, Did you eventually find a solution? I am currently trying to do the same thing. Thanks Claudia