|
[Sponsors] |
June 1, 2016, 16:39 |
Dunamic mesh
|
#1 |
New Member
behnamrha
Join Date: Jun 2015
Posts: 14
Rep Power: 10 |
Hi
i wanna model a rotational wall by dynamic mesh but after a few tomes from this motion my meshgrid change ina bad way in figure(1) is my rotational boundary and in figure(2) is meshgrid after a few time how I can solve this ? thank you photo_2016-06-01_13-32-16.jpg photo_2016-06-01_13-32-26.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |