|
[Sponsors] |
Pressure drop for Laminar flow (Re=190) in pipe does not match theoric |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 18, 2016, 08:34 |
Pressure drop for Laminar flow (Re=190) in pipe does not match theoric
|
#1 |
Member
Omid Shekari
Join Date: Jun 2016
Posts: 43
Rep Power: 9 |
The theoric pressure drop is about 6 kpa (everything has been checked several times) but fluent gives an amount of 3 kpa instead.
Any solution? Any special setting I need to change for low renold cases? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
Discrepancy between the measurements (pressure drop; VOF) | blackemperor | FLUENT | 2 | March 6, 2016 03:40 |
Modelling the two-phase flow Pressure Drop in a helical coil | Lancashire | Fluent Multiphase | 4 | August 12, 2015 04:49 |
Orifice-Pipe Problem | CFXMUFFIN | CFX | 3 | July 16, 2015 18:57 |
Pipe Flow - Pressure Drop | Daniel L | FLOW-3D | 2 | December 10, 2010 04:23 |