|
[Sponsors] |
How to set the boundary condition for mixing of two air stream. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 18, 2016, 11:29 |
How to set the boundary condition for mixing of two air stream.
|
#1 |
New Member
goku
Join Date: Jun 2015
Posts: 12
Rep Power: 10 |
Hi
I need some help to set the boundary condition for my problem. I am working on CFD study of HVAC. In mixing ventilation inlet air comes at 289 K and temperature of air inside the room is 300k and 1 atm for the entire fluid domain of the room is used as initial values. And the solution is runs at transisent condition. there are heat source inside the domain. How to set temperature of the fluid domain at 300 K as initial values? and solution stop once constant temperature has reached. Thanks in advance. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary condition of velocity and pressure at interface for air water pipe flow | jignesh_thaker2007 | OpenFOAM Running, Solving & CFD | 0 | June 10, 2014 17:42 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 12:32 |
Print results and set boundary condition | Kenneth Lam | Phoenics | 0 | September 22, 2007 01:42 |