 |
 |
 |
|
|
|
[Sponsors] | ||||
February 1, 2000, 15:10
|
Fluent/Gambit export to CAD
|
#1 |
|
Guest
Posts: n/a
|
Does anyone know how to export the geometry information backwards from Fluent or Gambit to CAD systems, such like AutoCAD?
|
|
|
||
|
February 2, 2000, 03:53
|
Re: Fluent/Gambit export to CAD
|
#2 |
|
Guest
Posts: n/a
|
Since GAMBIT is based on the ACIS-format which, I was told, is used by most CAD-System you should be able to export an ACIS-File which is then read by your CAD-Programm.
I hope this helps. Detlef |
|
|
|
||
|
February 2, 2000, 22:03
|
Re: Fluent/Gambit export to CAD
|
#3 |
|
Guest
Posts: n/a
|
Correct, both Gambit and AutoCAD are based on the ACIS geometry kernel. You can export an ACIS file from Gambit and import that into AutoCAD.
|
|
|
|
||
|
April 17, 2000, 12:41
|
Re: Fluent/Gambit export to CAD
|
#4 |
|
Guest
Posts: n/a
|
That is correct, but someone know how to export from Gambit to Pro/E?
|
|
|
|
||
|
April 17, 2000, 14:08
|
Re: Fluent/Gambit export to CAD
|
#5 |
|
Guest
Posts: n/a
|
Gambit 1.3, to be released in May, will have export of geometry in STEP, IGES, and Parasolid formats. STEP will be the best choice for Pro/E, as it supports solid models and is supported by Pro/E V20 and higher at no additional cost.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pro/engineer -> turbogrid import file | YIM SNAG PIL | CFX | 10 | July 5, 2015 01:52 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| Mesh export from Fluent to CAD | Piotr | FLUENT | 0 | September 29, 2005 00:27 |
| STAR-Works : Mainstream CAD with CFD | CD adapco Group Marketing | Siemens | 0 | February 13, 2002 12:23 |
| Importing I-DEAS unv file | hbetb | FLUENT | 1 | August 10, 2001 13:22 |
Linear Mode
