CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Boundary (http://www.cfd-online.com/Forums/fluent/27517-boundary.html)

KIAN February 23, 2000 13:33

Boundary
 
If I have one inlet and two outlet and I want to set them in 30% and 70% for each of the outlets respectively having the same length for the two outlet, how can I go about setting them.

John C. Chien February 23, 2000 14:01

Re: Boundary
 
(1). There are at least three solutions. (2). No.1 solution: adjust exit pressure at exit-1, and exit-2, until you get the right ratio. This is good for compressible flows. (3). No.2 solution: adjust the width of the exit-1 and exit-2, until you get the right ratio. This is good for incompressible flows. (4). No.3 solution: install a valve in one of the outlet and adjust it until the right ratio is achieved.

Pavel Strasak February 24, 2000 03:50

Re: Boundary
 
Or for incompressible flow you can use OUTFLOW, first with 0.3 and second with 0.7 flow rate weighting. Pa.St.


All times are GMT -4. The time now is 10:19.