Creation of an Inegral lower topology surface using Gambit 1.0.3

June 25, 2000, 22:04

Hi,

I want to create a geometry in which there is a cross-flow of fluid to the main flow in a pipe. Here I do not want to create a cross-flow pipe, instead a creation of a secondary injection surface on the side wall of the main flow pipe would suffice. Is there any option in Gambit 1.0.3 to create an inegral surfce on an upper topology surfcae?

Thanks in advance & Regards,

Remesh.

June 26, 2000, 02:58

Sorry,

Please read as "Integral" instead of "Inegral".

Regards, Remesh

June 25, 2000, 22:04	Creation of an Inegral lower topology surface using Gambit 1.0.3	#1
Remesh K Guest Posts: n/a	Hi, I want to create a geometry in which there is a cross-flow of fluid to the main flow in a pipe. Here I do not want to create a cross-flow pipe, instead a creation of a secondary injection surface on the side wall of the main flow pipe would suffice. Is there any option in Gambit 1.0.3 to create an inegral surfce on an upper topology surfcae? Thanks in advance & Regards, Remesh.

June 26, 2000, 02:58	Re: Creation of an Inegral lower topology surface using Gambit 1.0.3	#2
Remesh K Guest Posts: n/a	Sorry, Please read as "Integral" instead of "Inegral". Regards, Remesh

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Construct a three-sided surface in Gambit	User	FLUENT	0	March 26, 2005 04:49
Surface creation problems with GAMBIT !	enemi09	FLUENT	2	February 26, 2005 10:52
Thin Surface in Gambit	cfd guy	FLUENT	2	August 16, 2001 12:47
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19
Modelling hull surface by Gambit 1.2	Ieria Giovanni	FLUENT	0	February 23, 2000 04:03