|October 11, 2000, 23:35||
has anybody got any experience with using Fluent in a pseudo-steady mode?? By this I mean simulations in which you assume some equations are solved as steady (at each time-step) and some are solved as being fully transient.
I'm solving for a coal gasification reactor. In this case I'd like to assume steady gas flow (short residence time in my reactor) but still solve for transient heat flow and material balances. In this way I would hope to use large time-steps (say 2-10 mins) since I'm interested in dynamic peformance over long time frames.
Many models have used this approach in the past, but none are reported within a commercial CFD code. The scheme works in Fluent but I can't increase the time-step above about 1 second without stability problems. Has anybody tried this too?????
|Thread||Thread Starter||Forum||Replies||Last Post|
|Time step dependence of convergence behavior of steady state simulations in CFX||Chander||Main CFD Forum||5||December 23, 2013 06:31|
|Steady method without pseudo time||Vasiliy||Main CFD Forum||0||February 21, 2011 13:51|
|Steady solution from Transient simulations||wawa||FLUENT||2||November 9, 2010 18:44|
|Steady state verses Time accurate simulations||Saud khashan||Main CFD Forum||2||May 23, 2003 07:00|
|Psuedo Steady Simulations||Greg Perkins||Main CFD Forum||0||October 14, 2000 00:49|