 |
 |
 |
|
|
|
[Sponsors] | ||||
December 26, 2000, 02:50
|
how to setup reference value?
|
#1 |
|
Guest
Posts: n/a
|
Hi.
I am trying to simulate cylinder fluid use fluent 5.3.but i found my result of life,drag coef. not equal the result of other paper.but the curve is right.i setup refernce value as below: area:0.02 M^2 length:0.01 M v. : 0.01m/s b. : 1m can anyone tell me how to setup the right value? |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Second Derivative Zero - Boundary Condition | fu-ki-pa | OpenFOAM | 8 | July 3, 2011 20:58 |
| Error with Wmake | skabilan | OpenFOAM Installation | 3 | July 28, 2009 00:35 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| G95 + CGNS | Bruno | Main CFD Forum | 1 | January 30, 2007 00:34 |
| Building OpenFoAm on SGI Altix 64bits | anne | OpenFOAM Installation | 8 | June 15, 2006 09:27 |
Linear Mode
