|
[Sponsors] |
February 8, 2001, 11:58 |
Gambit meshing
|
#1 |
Guest
Posts: n/a
|
Guys I'm trying to mesh the surface only of a 'torpedo' shaped object. The volume was created by drawing half of a 2D airfoil, and rotating it about 360, about the x axis. When I try to mesh it, no matter what interval count I use, the mesher goes to 99% done, and then the number of elements climbs to 100000, and the program seems to stop. Has anyone had this problem ,and if so, does anyone know how I should try meshing it? Thanks in advance FP
|
|
February 9, 2001, 07:07 |
Re: Gambit meshing
|
#2 |
Guest
Posts: n/a
|
i think you should divide your object into pieces, then try to mesh in coarse mesh
|
|
February 9, 2001, 11:37 |
Re: Gambit meshing
|
#3 |
Guest
Posts: n/a
|
You should change the default to increase the number of triangles allowed (100,000) on a single geometrical face. EDIT Defaults -> Mesh -> Trimesh -> Max_faces. You can either assign a higher value or "-1", which means no limit.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
[GAMBIT] Desperate student needs help meshing 3D GAMBIT model - please help! | lau06165 | ANSYS Meshing & Geometry | 1 | March 22, 2010 01:09 |
Meshing problem in GAMBIT | Vidya Raja | FLUENT | 0 | May 20, 2006 23:31 |
Meshing Aircraft with Gambit | Ed | FLUENT | 5 | November 9, 2004 05:04 |