Home > Forums > FLUENT

plot3d->gambit, cyclic condition.

Mark Forums Read

Reply

February 23, 2001, 08:22	plot3d->gambit, cyclic condition.	#1
lhb Guest Posts: n/a	I imported mesh with plot3d formated, and want to exported it for fluent5. But when I applied cyclic condition in gambit, the mesh were erased automatically by gambit, only left the geometry. Who can tell me how can I exert the cyclic boundary condition upon the mesh. Thanks very much!

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
interFoam and cyclic boundary condition issue	General_Gee	OpenFOAM Running, Solving & CFD	13	March 11, 2013 11:18
Cyclic Boundary Condition	Asgarian	OpenFOAM Running, Solving & CFD	3	December 29, 2011 19:45
icem fluent mesh with cyclic boundary condition	jiejie	OpenFOAM	1	April 5, 2011 03:36
cyclic boundary condition doesn't work in a tube ??	Cyp	OpenFOAM	6	April 16, 2010 15:21
About Partial Cyclic Boundary Condition	Jiaying Xu	CD-adapco	2	October 31, 2002 20:12

All times are GMT -4. The time now is 20:50.