Home > Forums > FLUENT

grid in FLUENT5.5and FLUENT 4.5

Mark Forums Read

Reply

March 8, 2001, 08:19	grid in FLUENT5.5and FLUENT 4.5	#1
yueroo Guest Posts: n/a	Hi: I use gambit to bulid up multi-block (0type and H type grid )in cylinder tube. I read it in Fluent 5.5 ,I can get good result . But When I read this grid in FLUENT 4.5, some place in grid will break . Can someome tell me What I should pay attention in FLUEN 4.5 ? How to use gambit to bulid o-type mesh cylinder ? and that can read in FLUENT 4.5?

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mapping results from CFD grid to structural grid of a free-form surface	mbecker	OpenFOAM Running, Solving & CFD	0	December 22, 2010 05:12
MapFields to New Grid For Extreme Grid Deformations due to Body Motion	albcem	OpenFOAM	0	May 5, 2009 14:17
GRID TO GRID INTERPOLATION in FLUENT	calogero	FLUENT	3	June 4, 2003 08:32
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 04:59
Troubles modelling flow through a grid	Hans Klaufus	CFX	1	June 28, 2000 16:43

All times are GMT -4. The time now is 00:08.