 |
 |
 |
|
|
|
[Sponsors] | ||||
March 8, 2001, 08:19
|
grid in FLUENT5.5and FLUENT 4.5
|
#1 |
|
Guest
Posts: n/a
|
Hi: I use gambit to bulid up multi-block (0type and H type grid )in cylinder tube. I read it in Fluent 5.5 ,I can get good result . But When I read this grid in FLUENT 4.5, some place in grid will break . Can someome tell me What I should pay attention in FLUEN 4.5 ? How to use gambit to bulid o-type mesh cylinder ? and that can read in FLUENT 4.5?
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mapping results from CFD grid to structural grid of a free-form surface | mbecker | OpenFOAM Running, Solving & CFD | 1 | October 18, 2013 10:16 |
| MapFields to New Grid For Extreme Grid Deformations due to Body Motion | albcem | OpenFOAM | 0 | May 5, 2009 14:17 |
| GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 08:32 |
| Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 05:59 |
| Troubles modelling flow through a grid | Hans Klaufus | CFX | 1 | June 28, 2000 16:43 |
Linear Mode
