 |
 |
 |
|
|
|
[Sponsors] | ||||
April 10, 2001, 18:30
|
How to specify Hardcopy to save
|
#1 |
|
Guest
Posts: n/a
|
Dear all, How to specify a paricular window graphic to save a hardcopy, there are three graphic window,1.display contour,2.display resodual,3. display one surface monitor,I want to save surface monitor graphic,but each time the velocity contour graphice was saved,how to specify desired window to save graphic as a hardcopy,many thainks in advance.
|
|
|
||
|
April 11, 2001, 05:31
|
Re: How to specify Hardcopy to save
|
#2 |
|
Guest
Posts: n/a
|
Press you mouse in the window you want to saved,and then hardcopy, it will be ok.
|
|
|
|
||
|
April 13, 2001, 16:01
|
Re: How to specify Hardcopy to save
|
#3 |
|
Guest
Posts: n/a
|
Go to Display--> Option and activate the desired window there.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How can I save a mesh file in ANSYS Workbench V12 for standalone mode CFX-Pre? | fkonias | ANSYS Meshing & Geometry | 22 | March 18, 2017 09:38 |
| How to save images of contour plots during parallel job | Neil11 | FLUENT | 5 | September 23, 2010 19:06 |
| how to save the hardcopy in every time step | yubaibai88 | FLUENT | 12 | May 27, 2010 09:28 |
| How to save 2-D data in contour plot | mssound | FLUENT | 0 | February 15, 2010 14:01 |
| How to save only a slice,not the whole data? | leon | Siemens | 3 | August 25, 2005 10:55 |
Linear Mode
