|
[Sponsors] |
April 16, 2001, 09:25 |
S.O.S:A problem about meshing.
|
#1 |
Guest
Posts: n/a
|
Hi, I am calculating velocity and press field of flow in heat exchanger now. The shell-and-plate heat exchanger was column with helical baffle.But I can not mesh the volume by using gambit ! I am use fluent juet now . Please tell me what should I do? Give me your hand! Thank you ! (My email:qiuwuyu@263.net )
|
|
April 23, 2001, 04:16 |
Re: S.O.S:A problem about meshing.
|
#2 |
Guest
Posts: n/a
|
Hi, Two points: (a)See the error message printed by the gambit in the left-lowest of the screen. (b)reduce the mesh spacing(or space)to one smaller value(it's default value is 1). hope to help you. Harry.
|
|
April 23, 2001, 06:01 |
Re: S.O.S:A problem about meshing.
|
#3 |
Guest
Posts: n/a
|
Thank you for your help! The error message is :
Assertion failed in Fcae PrepTool.cc, line336:test_valence>=min_valence while meshing valume 94. But I don't know what does it mean?Can you tell me! Thanks! |
|
April 23, 2001, 07:36 |
Re: S.O.S:A problem about meshing.
|
#4 |
Guest
Posts: n/a
|
Hi,
sorry,I don't know what it means too. But check the volume 94 meshing in detail. Another point is that you should specify the zone boundary type only after you meshes the entity. Sincerely, Harry. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with querying the meshing database in CFX-Pre | ashtonJ | CFX | 18 | April 18, 2023 23:49 |
[Other] Hex meshing problem DM12 | patrick | ANSYS Meshing & Geometry | 7 | January 9, 2015 07:21 |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 20:03 |
[ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
Meshing problem | Sanjay Jain | FLUENT | 6 | April 5, 2008 09:51 |